Table of Contents
Advertisement
10
INSTALLATION
c.
Convert 6" top round to 3-1/4"x10" top rectangular.
d.
Replace the 6" round duct with the half round section duct. (Fig. 3a-3b)
Fig. 3a
e.
Install the "rectanular section" transition plate on next. (Fig. 3c)
Fig. 3c
f.
Secure both plates with the screws provided. (Fig. 3d)
(Fig. 3d)
g.
Conversion is complete after both plates are secured. (Fig. 3e)
(Fig. 3e)
INSTALLATION
h.
Feed the wires coming out of the unit through the bottom of the cabinet.
i.
Lift the unit up flesh against the wall and the bottom of the cabinet.
j.
Using the screws and washers provided, insert into each of the 4 keyhole
Note: Install more screws through the back of the unit if necessary
k. Connect 3-1/4" x 10" rectangular ducting to the collar of the hood.
Fig. 3b
l.
Finish off by sealing the connection point with aluminum tape
4. Under Cabinet Installation (Rear Rectangular Outlet) (OPTIONAL)
a.
Make sure all preparation steps are completed
b.
Be sure you have the WSC-46RVK (Rear Vent Kit) to change the top
c. Convert 6" top round to 3-/4" x 10" rear rectangular
d.
Replace the 6" round duct with half round section duct (Fig. a-b)
e.
Use a flat-head screwdriver to pry open the rear outlet cover. (Fig. c)
openings (2 on each side) and tightly secure the unit against the bottom
of the cabinet.
round outlet to a rear rectangular outlet
Fig. 4a
Fig. 4c
11
.
Fig. 4b
Advertisement
Table of Contents
