Depth Units Of Measure; Preset Unit (Reset All Options); System Info; Simulator - Eagle 128 Installation And Operation Instructions Manual

DEPTH UNITS OF MEASURE

This unit can show the depth in feet or meters.
To change the depth units of measure, press
until the
the desired unit of measure, then press the
the menu.

PRESET UNIT (reset all options)

This command is used to reset all features, options and settings to their
original factory defaults. This is useful when you have changed several
settings and want to return the unit to basic automatic operation.
Turn the unit off. Press and hold the
key at the same time while you press the
DOWN
keys as the unit powers up. The unit will turn on with factory settings
restored.

SYSTEM INFO

To show the operating software system information, press
until the
MENU DOWN
clear the screen.

SIMULATOR

occasionally to remind you that the simulator is on.
To use the simulator, press
menu appears. Press
the menu. Repeat the above steps to turn it off, or you can simply turn
the unit off and back on again.
menu appears. Use the arrow keys to select
U
NITS
U I
NIT
This unit has a built-in simulator that shows a simulated
bottom signal with fish signals. This lets you practice with
the unit as if you were on the water; all features and
functions of the unit are usable. A message appears
UP ARROW
DOWN ARROW
menu appears. Press
NFO
repeatedly until the
MENU DOWN
to turn it on, and press
48
MENU DOWN
key to clear
PWR
key and the
key. Release the
PWR
to
PWR
S
PWR
MENU
IMULATOR
to clear