Eagle 128 Installation And Operation Instructions Manual page 23

In-dash mounting template for Cuda 168EX, showing dimensions.
NOTE: The preceding figure is not printed to scale. A scaled template
is available for free download from our web site, www.eaglesonar.com.
For the Cuda 128 and Cuda 168
The Cuda 128 and Cuda 168 both use the same case and can be mounted
in-dash using the removable scaled template inside the back cover of this
manual (page 55). The FM-6 mount kit includes the necessary materials,
but the instructions only appear here in this manual.
Please read all the instructions before proceeding. NOTE: Recommended
tools for this job include: jig saw, drill, drill bit (for starting hole).
1. Select the desired mounting location. Make sure there is enough room
behind the dash to attach the unit's cable. The case is approximately
1-3/4" (45 mm) behind the mounting surface. You also need to allow an
additional 1" (25 mm) for the power/transducer cable and connector.
2. Cut or tear out the template in the back of this manual (page 55) and
tape it to the dash. Begin the cutout by drilling a starter hole near the
center of the template. Use a drill bit big enough for the jigsaw blade.
146.5
[5.76]
Top
In-Dash
Template
Millimeters
[Inches]
ALWAYS VERIFY DIMENSIONS
19
R 7.9
[0.31]
113.5
[4.46]