Setting Parameters; Level Build Plate Before Initial Print - FLASHFORGE 3D PRINTER Creator X Startup Manual

Should you encounter any problems, please feel free to email me at: 597891915@qq.com
control panel and manually modify the temperature in the "Right Target" setting for the extruder
temperature control changing the temperature to 220 degrees. A red line will be plotted in the
temperature map. When the actual (Current) temperature reaches 220 degrees you can pull the
filament out.

Setting parameters

Before generating Gcode, specific parameters can be set up to customize various aspects of the print.
An explanation to each of the settings can be found in a

Level Build Plate before initial print

First, make sure that you've completed all the steps in the
1. your DualExtruder should be bolted in place,
2. your filament guide tubes connected,
3. and your spools of filament mounted on the spool holders.
4. Once all these have been completed, you can plug in your power supply.
If everything is ready, then flip on the power button on the back of your Creator X.
Go to Utilities->Level Build Plate
Pay close attention: leveling your platform is very important to print quality!
Here's the first screen
Actually Creator X has only three knobs on the bottom of the platform, just inside the plastic arms
that hold it up. Creator X has been leveled perfectly before leaving factory. However, it will get
unleveled during long distance shipping. Please do level the build plate again before starting a print.
, Leveling Your Platform
18
previous section.
Un-boxing and Hardware Setup section: