FLASHFORGE 3D PRINTER Creator X Startup Manual page 6

Should you encounter any problems, please feel free to email me at: 597891915@qq.com
accessory box, and the appropriate hex wrench.
First, lower the build platform using one of the methods described in the previous section. Holding
the extruder by both sides, take it out of the accessory sleeve and position it on the extruder seat
with the fan facing forward. Align the screw holes and fasten with the two short silver screws.
Next is the installation of the spool holder. Install one on each side.
The installation of the spool holder is very simple – just insert it into the circular opening and
tighten the nut behind.
Then install the filament guide tube to the empty spot on the extruder, put one end of the guide
tube into the hole.
The hardware installation is almost complete.
Next, with the power switch in the 'OFF' position, confirm that the power cord is plugged into the
power outlet next to the power switch. ***Remember to verify your power supply is set to the
proper voltage for your location.
4