Download Print this page
Hide thumbs Also See for Truesight:

Advertisement

Quick Links

Truesight
Truesight
Navigation
®
Steering Wheel Button
• Tapping this button engages/
disengages Truesight
• Holding this button for more than 3
seconds enables/disables the Auto-
Engage feature
Red X (Escape Command)
• Taping the Red X moves back one
level in the menu
Black Scroll Knob
• Raises or lowers the Bump value
• Scrolls to next or previous value in a
menu or list
Green Check Mark (Enter Command)
• Taping the Check Mark selects the
options displayed
Truesight
Status LED
®
Truesight Base LED
Not connected to remote but has power
Connected to Remote
Truesight Remote LED
Truesight Engaged
Quick Reference Guide
®
Menu Layout
Setup
Range
Tilt Range
Aux Engage
Alert Timer
LCD Backlight
LCD Contrast
Adavnce Setup
Deadband
Gain
Auto Engage Delay
Override Value
Speed Select
Speed Value
Gain Balance
Right Dead Zone
Left Dead Zone
Fine Control
System Select
Range 2
Calibrate
Center Bump
Wheel Angle
Auto Engage Height
Speedometer
Tilt Sensor
Auto Decect Dead
Zone
Optimization
Range:
Diagnostics
Inputs/Outputs
is the most important step for optimum
Crop
steering response.
Crop2
Wheel Angle
Increase the Range if:
Tilt
• You notice a gentle weave
Steering Wheel
Disengage
• Does not turn sharp enough to go
Safeties
Auto Engage
Motor L/R
Decrease the Range if:
Valve L/R
• The rear wheels jerk constantly
Speedometer
Last Disengage
Steering Test
Deadband:
Error Codes
movement without causing any correction
Clear Errors
Decrease the Deadband if:
About Truesight
• The system wanders in the row
Hardware
Software
Headsight
Increase the Deadband if:
Box Timers
• The system is steering excessively
Bootload Base
Reset Defaults
Gain:
of steering response for a given error.
Higher Gain
• A higher gain setting will result in a
• Increasing the gain may improve
Properly adjusting the range
around a curve
The amount of sensor
without even trying to turn the wheels
often even on relatively straight rows
The Gain setting controls the speed
quicker response
responsiveness, but will have a
tendency to make the system jerky

Advertisement

loading

Summary of Contents for Headsight Truesight

  • Page 1 The Gain setting controls the speed • Auto Decect Dead of steering response for a given error. Zone Truesight Base LED Higher Gain • A higher gain setting will result in a Not connected to remote but has power quicker response Connected to Remote •...
  • Page 2 Auto Engage Sensor Calibration When the header passes below the chosen height, Truesight will delay Wheel Angle Sensor Calibration a short time and then begin steering. 1. To calibrate go to >>Calibration>>Wheel Angle 1.