(16) Spray mold release compound on rubber coated leads of the magneto harness.
(17) Connect the harness cap to the respective
magneto with three screws shown in Figure
6. Tighten the three screws until all screws
are touching the harness cap to ensure that
there is an even gap around the cap.
(18) Torque the three screws to 18 to 20 in.-lb.
(2.0 to 2.3 Nm) in the sequence shown in
Figure 7 as a final torque.
74-30
Page 174
YO-233-B2A Engine Maintenance Manual
TEO-540-A1A Engine Maintenance Manual
Torque Sequence for Screws
on Magneto Harness Cap
© 2021 Avco Corporation. All Rights Reserved
Figure 6
February 2021