Remote Control Unit - JVC AV-P1000U Operating Instructions Manual

Remote control unit

● The remote control unit should be operated by directing it toward the remote control light reception section of the main unit. The range of
the remote control unit is up to about 7 m on the front axis of the remote control light reception section (when new batteries are used). The
light reception range is up to 20˚ to the left and right or up and down from the front axis.
● Before using for the first time, be sure to install the two provided batteries (AA). Open the battery case cover on the rear of the remote
control unit. Then, set the batteries in the correct direction by referring to the plus and minus indications shown in the case.
1
VIDEO OUT (p. 12)
● Press to output composite signals from the camera to the VIDEO OUT connector.
● Press again to output signals to the RGB OUT connectors.
2
AUTO WHITE (p. 11)
● Adjusts the tone of a picture.
3
IRIS (p. 13)
● Use to adjust picture brightness. Press the
button to darken the picture.
● Press the
and buttons simultaneously to set the iris value to 0.
4
PICTURE MEMORY
● Up to 3 pictures from the camera can be stored in memory as still images.
● When the picture you want to store is displayed, press one of the PICTURE
1
MEMORY buttons to
upper left of the screen, "M1", "M2", or "M3" will appear briefly to confirm the
image has been saved.
● To call a stored picture, press one of the PICTURE MEMORY buttons
● Press again to restore the previous picture.
Note:
● Pictures stored in memory are not saved when the power is turned off.
● When an image is output from the VIDEO OUT connector, the [PICTURE
MEMORY 1 to 3 ] buttons will not operate.
5
LIGHTS (p. 13)
● Each time this button is pressed, the illumination switches as follows.
Side illumination lights.
6
D-ZOOM (p. 10)
● Press to enlarge a picture electronically.
7
FREEZE (p. 11)
● Press to freeze a picture from the camera.
● Press again to release the picture freeze mode.
● When the split mode is engaged with the ON-SCREEN ADJUSTMENTS, a still
image and camera picture can be displayed on a divided screen.
8
PC (p. 12)
● Press to output the signals from the equipment connected to the PC IN connec-
tor to the RGB OUT connectors.
● Press again to restore the previous signals.
9
FOCUS (p. 11)
● Press these buttons to adjust the focus.
0
ZOOM TELE/WIDE (p. 10)
● Press the TELE button to enlarge the picture size and the WIDE button to reduce it.
16
button to brighten and the
3
for more than 2 seconds to store it in memory. In the
Back illumination lights.
VIDEO
OUT
1
4
PICTURE
MEMORY
LIGHTS D-ZOOM
5
6
1 PRESET
!
MENU
@
1 3
to .
POINTER
$
No illumination.
2
3
AUTO
WHITE
IRIS IRIS
1 2 3
7
FREEZE PC
8
9
NEAR FAR
FOCUS
TELE WIDE
2
0
ZOOM
#
%
REMOTE CONTROL UNIT
SSV3789