System Connections - JVC AV-P1000U Operating Instructions Manual

System connections

Controlling this unit externally
The control panel and the ON-SCREEN ADJUSTMENTS functions can be controlled via an external device such as a personal
computer.
Information on communication protocols and commands is available separately. For details, consult your JVC dealer.
Connection with a personal computer
1.
Turn this unit and the personal computer off.
2.
Connect the personal computer to the REMOTE IN connector on the rear panel of this unit with an RS-232C cable.
3.
Turn this unit and the personal computer on.
4.
Set the computer's RS-232C communication settings as specified in the interface specifications.
5.
Start up the control program on the computer.
Interface specifications
•
Communication method : Full duplex asynchronous
•
Baud rate
•
Start bit
•
Stop bit
•
Data length
•
Parity
RS-232C Cable
Connection to a serial port
(AV-P1000)
D-sub 9-pin female
Connector pin assignments and signal name
RGB OUT2 connector
PC IN connector
5
10
15
Pin No. 1 2
Signal name RED GREEN
: 9600 bps
: 1 bit
: 1 bit
: 8 bits
: Even parity
CD 1 ................................................... 1
TXD 2 ................................................... 2
RXD 3 ................................................... 3
DTR 4 ................................................... 4
SG 5 ................................................... 5
DSR 6 ................................................... 6
RTS 7 ................................................... 7
CTS 8 ................................................... 8
RI 9 ................................................... 9
1
(female)
6
11
3 4 5 6
BLUE NC GND GND
CD
RD
TD
DTR
SG
DSR
RTS
CTS
RI
7 8 9 10
GND GND NC GND
(PC)
D-Sub 9-pin female
11 12 13 14 15
NC NC Hs/Cs Vs NC
19