Before Use - JVC AV-P1000U Operating Instructions Manual

BEFORE USE

1.
While pressing down the lock release button
camera arm with your hand and raise it in the direction
2
shown . When the camera arm stops, release the lock
release button.
Be sure to raise the camera arm until the lock release but-
ton is released and the camera arm is completely locked.
● To change the camera angle using the 5-position cam-
era arm function, press the lock release button again.
After changing the angle, fix the camera arm at the
position where the lock release button is released and
the camera arm is locked.
Note:
● Do not release the camera arm when the lock release
button is pressed. Otherwise, a malfunction or injury
may result.
2.
To aim the camera head at the stage, turn it in the direction
3
shown until it clicks.
3.
Fold out the side illumination arms in the direction
Note:
● Do not move the side illumination arms in any direc-
tion other than that shown
sive force to the lamps when changing the angle. Oth-
erwise, a malfunction or electric shock may result.
4.
Check the type of input connector on the display or monitor
and make the appropriate connections.
● BNC Connection
BNC-BNC cable
2 3 A B C D
1 4
1
0
SYNC.
MODE REMOTE IN (RS-232C)
RGB OUT1 To the RGB OUT1
RGB OUT2
connectors
R G B Hs/Cs Vs
RGB OUT1
RGB OUT1
R G B Hs/Cs Vs
● Composite Video Connection
2 3 A B C D
1 4
1
0
SYNC.
MODE REMOTE IN (RS-232C)
RGB OUT1
VIDEO OUT
RGB OUT2 PC IN
R G B Hs/Cs Vs
VIDEO OUT
5.
Connect the power cord connector to the AC IN connector
and plug the other end into an AC outlet. Press the power
switch to turn the power on.
6
1
, hold the
4
.
4
. Do not apply exces-
To video input
connectors
Display
Provided video cable
To the VIDEO OUT To the video
connector input connector
Monitor
1
4
● D-sub 15-pin Connection
D-sub 15-pin cable
A B C D
2 3
1 4
1
0
SYNC. REMOTE IN (RS-232C)
MODE
RGB OUT1
RGB OUT2
R G B Hs/Cs Vs
RGB OUT2
* Use the shortest cable possible (3 m. max.) for RGB con-
nections.
Note:
If the D-sub cable connector plugged into the RGB
OUT2 connector is too large, you won't be able to con-
nect a cable to the PC input connector.
Notes:
● Be sure to turn the power off to protect this unit and other
connected equipment.
● Do not connect any device with more than the indicated
power (400 W) to the AC outlet. Doing so could result in
overheating and produce smoke or fire.
2
3
4
(Male) (Male)
To the RGB OUT2 To the video
input connector
connector
Display