Quick Start; Quickly Build A Zigbee Network - Ebyte E18-DTU Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
0x0003 Send Mode
0x0004 LP Level
0x0006 Modbus ID
0x0010 User Attr 0
0x0011 User Attr 1
0x0012 User Attr 2
0x0013 User Attr 3
Baud: Modify this parameter to set or query the current baud rate of the module.
targetAddr: The target address in the transmission mode, 0xFFFF is broadcast transmission, and 0xFFFE is sent to the binding
target MAC.
targetEP: The target port in the transmission mode, set the value to 0xFF for broadcast sending or binding sending, set it to 0x01
for sending to the specified target short address, and set it to 0x00 for multicast sending.
send Mode: transmission mode setting, 0 - HEX command mode, 1 - normal transmission mode, 2 - no response mode, 3 - no
printing mode, 4 - Modbus host mode.
target IEEE: bind the target MAC, this item is only for viewing. The module can bind multiple target MACs, and the heartbeat
packet will be sent to all bound MACs in turn, but in the transmission mode, only the data is sent to the last binding target in the
binding table.
Modbus ID: The module will send this parameter to the coordinator and the bound target MAC in the form of a heartbeat packet
(once every 300 seconds). If the target device is a Modbus master, the Modbus master can find the zigbee network address of the slave
according to the Modbus ID of the slave.
User-defined variables: There are one 32bit, one 16bit, and two 8bit, total 4 user-defined variables. These values can be set and
queried through "Read Local Attributes" and "Set Local Attributes", remote setting and query are also supported to facilitate the status
management of the module.

5 Quick Start

In order to allow users to quickly familiarize themselves with the radio, this section will guide users to build a ZigBee network
through simple configuration with the host computer, including node type configuration, PANID setting, channel setting, and transmit
power setting.

5.1 Quickly build a ZigBee network

Combined with the host computer software to quickly and easily establish a ZigBee network, the specific steps are as follows:
(1) Connect the radio to the computer, open the host computer software "Ebyte ZigBee3.0 Setting", select the device type, select the
Copyright © 2012–20 23 , Chengdu Ebyte Electronic Technology Co., Ltd.
Transparent mode bool
low power mode enum8
Modbus number uint8
user-defined variable uint32
0
User-defined variable uint16
1
User-defined variable uint8
2
User-defined variable uint8
3
RWP 0
RP 0
RWP 0xFF
RW 0x00000000
RW 0x0000
RW 0x00
RW 0x00
E18-DTU Series User Manual
13