Console At The Driver's Seat; Battery Disconnector Relay Switch; Steering Wheel Panel; Multi-Function Switch - Kärcher MC 250 Manual

7.8

Console at the driver's seat

A console with switches, a storage container for various
small parts and sockets for USB and 12V is located next to
the driver's seat.
Storage container
1
Drain recycling water switch (optional with sweeping at-
2
tachment kit)

Battery disconnector relay switch

3
Waste container emptying switch (optional with sweep-
4
ing attachment kit)
Additional socket 12V / max. 10 A
5
USB connection 5V / max. 2.1A
6
7.8.1 Battery disconnector relay switch
All functions used for the vehicle can be deactivated with
the battery disconnector relay switch.
Switch setting "Disconnect battery"
1
Switch setting "Activate battery"
2
1. Disconnect the battery each time the vehicle is parked
by pressing the switch to the "Disconnect battery" posi-
tion. Please wait at least 60 seconds after switching off
the combustion engine before operating the switch.
Note: After the combustion engine has been switched
off, the control units are gradually deactivated. The bat-
tery can only be disconnected after the last device has
shut down. Therefore, observe the waiting time of 60
seconds.
2. To start up, activate the battery by pressing the switch in
the "Activate battery" position.
7.9

Steering wheel panel

Steering wheel
1
Display with function buttons
2

Multi-function switch

3
Steering wheel knob
4
Travel direction selector switch
5
7.9.1 Multi-function switch
● Horns: Press the button on the end
● Flash to the right: Lever forwards
● Flash to the left: Lever backwards
● High beam: Press the lever down with the driving light
switched on
● Flasher: Pull lever and release
● Windscreen wiper interval: Turn the ring forward
Note
The period of the wiper interval is adjustable (programma-
ble).
To do this, turn the ring to "Intermittent wiping", wait for the
desired time interval then switch it off and switch it on again
within 1.5 seconds. The set time interval returns to its basic
programming after switching off the ignition.
● Continuous wiping: Turn the ring backwards
Note
1st level for normal wiping speed
2nd level by turning further for fast wiping speed
● Wiping water: Press the ring
English 51