Launch Creader 629 User Manual page 22

LAUNCH
The MIL will stay lit for both Type "A" and Type "B" codes until one of the
following conditions occurs:
• If the conditions that caused the MIL to light are no longer present for the
next three trips in a row, the computer automatically turns the MIL "Off" if no
other emissions-related faults are present. However, the DTCs remain in
the computer's memory as a history code for 40 warm-up cycles (80 warm-
up cycles for fuel and misfire faults). The DTCs are automatically erased if
the fault that caused them to be set is not detected again during that period.
• Misfire and fuel system faults require three trips with "similar conditions"
before the MIL is turned "Off." These are trips where the engine load, RPM
and temperature are similar to the conditions present when the fault was
first found.
Note: After the MIL has been turned off, DTCs and Freeze Frame data stay
in the computer's memory.
• Erasing the DTCs from the computer's memory can also turn off the MIL. If
a Diagnostic Tool or Scan Tool is used to erase the codes, Freeze Frame
data will also be erased.
www.x431.com +86 755 8455 7891
629 User's Manual
17