Change Hydraulic Fluid - Toro Reelmaster 5200-D Service Manual

Change Hydraulic Fluid

Change hydraulic fluid after every 800 operating hours,
in normal conditions. If fluid becomes contaminated,
contact your local TORO distributor because the system
must be flushed. Contaminated fluid looks milky or black
when compared to clean oil.
1. Turn engine off and raise hood.
2. Remove drain plug from bottom of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and tighten
plug when hydraulic fluid stops draining.
IMPORTANT: IMPORTANT: Use only hydraulic
fluids specified. Other fluids could cause system
damage.
3. Fill reservoir with approximately 8.5 gallons (32 L) of
hydraulic fluid. Refer to Checking Hydraulic Fluid.
4. Install reservoir cap. Start engine and use all hydrau-
lic controls to distribute hydraulic fluid throughout the
system. Also check for leaks. Then stop the engine.
5. Check level of fluid and add enough to raise level to
FULL mark on dipstick. DO NOT OVER FILL.
Hydraulic System
1
Page 4 - 40
Figure 33
1. Hydraulic reservoir
cap
1
Figure 34
1. Drain plug
Reelmaster 5200-D/5400-D