Service And Repairs; Steering Wheel; Removal; Installation - Toro Reelmaster 5200-D Service Manual

Service and Repairs

Steering Wheel

Removal

1. Remove cover from center of steering wheel.
2. Remove the locknut that secures the steering wheel
to the shaft. Pull the steering wheel and foam seal off the
steering valve shaft (Fig. 14).
Note: It may be necessary to use a jaw-type puller to
remove the steering wheel from the steering shaft.
IMPORTANT: DO NOT hit the steering shaft with a
hammer. This could damage the steering valve com-
ponents.

Installation

1. Use the steering wheel to put the rear wheels in the
straight ahead position.
2. Slide the foam seal and the steering wheel onto the
steering shaft and secure the steering wheel in place
with the jam nut (Fig. 14). Tighten the nut to 10 to 15 ft-
lbs. (13 to 20 Nm).
3. Install steering wheel cover.
Steering and Brakes
2
1
1. Steering wheel
2. Locknut
Page 7 - 10
3
4
Figure 14
3. Cover
4. Foam seal
Reelmaster 5200-D/5400-D