Model 03527, S/N 210000001 & Up Model 03528, S/N 210000001 & Up; Specifications; Specifications - Toro Reelmaster 5200-D Service Manual

Specifications

REEL CONSTRUCTION: Fairway reels. All welded. 5
or 8 blades.
HEIGHT OF CUT RANGE:
5 Blade - 5/8" to 1" (13-25 mm)
8 Blade - 1/4" to 5/8" (6-16 mm)
Note: Heavy duty bedknife Part No. 100-3350 available
for height-of-cuts over 1/2" (13 mm).
REEL DIAMETER: 5 in. (127 mm)
REEL BEARINGS: Taper roller bearings
POWER: Hydraulic motor splined to reel shaft. Reel mo-
tors feature quick disconnect for removal or installation
onto cutting unit.
BEDKNIFE AND BEDBAR ADJUSTMENT: Opposing
fine thread screws
HEIGHT–OF–CUT & ROLLER ADJUSTMENT:
Front: 3 fixed positions for setting cutting unit attitude.
Optional Adjustable Front Height Of Cut kit, part no.
104–8205, allows for variable adjustment to cutting unit
attitude with adjustable height of cut rods, within the
height of cut range of 1/4" to 1 3/8".
Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)
Figure 1
Rear: Screw adjustable with bolt clamp lock used for
setting height of cut.
Selected Clip Control: The Reelmaster 5200/5400 is
equipped with manually adjustable reel speeds (275
rpm to 2000 rpm) which control selected clip.
Rollers: Front roller is a 3" (76 mm) diameter cast
Wiehle roller. Rear roller is a 2.5" (64 mm) diameter
steel full roller. Both rollers use heavy duty ball bearings
with two conventional single lip seals and a Toro laby-
rinth seal to provide four sealing surfaces to protect the
bearings.
OPTIONS & KITS:
Basket Kit (3 baskets)
Rear Roller Brush Kit
Wiehle Roller Scraper
Rear Roller Scraper Kit
Shoulder Wiehle Roller
Shoulder Wiehle Scraper
Comb Kit
Adjustable Front H.O.C. kit
Page 8.1 - 2
Rev. A
Model 03532
Model 03533
Part No. 104-3380-03
Part No. 104-3395
Part No. 104-3369
Part No. 104-8208-03
Part No. 104-3385
Part No. 104-8205
Reelmaster 5200-D/5400-D