Toro Reelmaster 5200-D Service Manual page 185

20.Using a dial indicator, check the ring gear backlash
in three equally spaced points. Ring gear backlash
should be .003-.007 inch (.076-.178 mm) and must not
vary more than .002 in. between points checked
(Fig. 53).
If the backlash is not in this range, move the shims which
are located beneath the differential bearings, from one
side to the other until the correct backlash is attained.
21.Check ring to pinion gear engagement (see Ring and
Pinion Gear Engagement in this chapter of the manual).
22.Apply silicone sealant between the front and rear
axle housings and install the eight housing cap screws.
Tighten the cap screws to a torque of 18-23 ft-lbs.
(24-31 Nm) (Fig. 54).
Reelmaster 5200-D/5400-D Page 6 - 23
Rev. A
Figure 53
Figure 54
Differential Axle