Transmission Control Linkage - Toro Reelmaster 5200-D Service Manual

Transmission Control Linkage

1
2
26
29
1. Cotter pin
2. Flat washer
3. Cap screw
4. Screw
5. Not used
6. neutral switch
7. Switch plate
8. Extension spring
9. Lock nut
10. Cap screw
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect both wires from neutral switch.
CAUTION
The extension spring is under tension. Loosen
lock nut from eye bolt to relieve spring tension.
3. Remove eyebolt from the spring anchor plate and
extension spring from the switch arm.
4. Remove cotter pin and washer to disconnect traction
control rod from pump control.
5. Loosen cap screw and lock nut securing pump con-
trol to swashplate control shaft.
Reelmaster 5200-D/5400-D
4
9 10
6 7
11
8
3
23
22
19
21
20
9 28 27
25
24
17
18
9
16
Figure 37
11. Ball bearing
12. Spacer
13. Cap screw
14. Not used
15. Traction plate
16. Spring anchor plate
17. Lock washer
18. Cap screw
19. Flanged bushing
20. Grease fitting
Page 4 - 43
12
11
9
13
15
19
22
21. Switch arm
22. Thrust washer
23. Traction stud
24. Hex nut
25. Pump control
26. Rubber bushing
27. Eyebolt
28. Hex nut
29. Traction control rod
Note: It is not necessary to disassemble transmission
control assembly further.
6. Remove four cap screws securing traction plate to
transmission housing. Remove transmission control as-
sembly from transmission.
Installation
1. Position traction plate to the transmission. Secure
traction plate to transmission housing with four cap
screws.
2. Secure pump control to swash plate control shaft
with cap screw and lock nut.
3. Reconnect traction control rod to pump control with
washer and cotter pin.
4. Reinstall eyebolt and extension spring. Connect
both wires to the neutral switch.
5. Adjust traction control neutral (see Adjust Traction
Drive for Neutral).
Hydraulic System