Safety Checks - Interacoustics Orion Installation Instructions Manual

6.5

Safety checks

Before beginning the test in the chair system, certain safety tests to be done as described below.
Safety checks for new for Orion AT/C
- Watchdog safety: Make sure the Estop has been disengaged. The Estop will remain off until one
enters the VisualEyes software and clicks on Begin Testing or goes into System Default Settings 
Rotational Chair and selects Orion A/C. Exiting VisualEyes will turn off the Estop light after a few
seconds. This ensures the Watchdog safety is working.
- Booth door safety: Click Begin testing with the booth door open. You should receive a message
alerting that booth door needs to be closed to continue testing. Close the booth door and go to a
Rotational chair test. You will get a safety checklist. The list needs to be checked before test can
begin.
At this point, the Orion AutoTraverse / Comprehensive Rotational Chair has been installed and can be used
to test patients.
If all the system checks are passsed, then your system is ready for use.
D-0120794-C – 2019/11
Orion Rotary Chair Installation Instructions Page 39