DISCLAIMERS The information in this manual has been carefully checked and is believed to be accurate. CYP (UK) Ltd assumes no responsibility for any infringements of patents or other rights of third parties which may result from its use. CYP (UK) Ltd assumes no responsibility for any inaccuracies that may be contained in this document.
SAFETY PRECAUTIONS Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply. Please keep the following in mind as you unpack and install this equipment: • Always follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.
Page 5
CONTENTS 1. Introduction ...........6 2. DRIVER PROPERTIES ......6 3. IP NETWORK CONNECTION ....6 4. DEVICE SPECIFIC COMMAND ....7 4.1 Set Power Reboot ........7 4.2 Set Auto Switching Mode ....... 7 4.3 Set Key Lock ..........7 4.4 Set Route Preset ......... 7 4.5 Set HDBT Audio Mode ......
1. INTRODUCTION This driver has been designed to provide two-way control of the CYP 9x2 Multi-format Presentation Scaler, via RS232 or TCP/IP. 2. DRIVER PROPERTIES The property of this driver is shown below. Figure 1: Driver Properties Driver Version Driver version number...
Page 7
4. DEVICE SPECIFIC COMMAND In addition to the usual A/V Scaler functionality supported by Control4, there are a number of device specific commands for the A/V Scaler switching. 4.1 Set Power Reboot Power Status Reboot 4.2 Set Auto Switching Mode Video Output Channel HDMI or HDBT Switching Mode OFF or Auto Switch 4.3 Set Key Lock...
Page 8
4.6 Set Audio Mixer Source Volume Volume(dB) -120 to 18 4.7 Set Microphone Mode Microphone Mode Front Panel or WebGUI 4.8 Set Microphone Volume Volume(dB) 0 to 60 4.9 Set Audio Mixer Line Volume Volume(dB) -120 to 18 4.10 Set Analog Output Volume Volume(dB) -103 to 24 4.11 Set Analog Output Mute...
Need help?
Do you have a question about the EL-2600V and is the answer not in the manual?
Questions and answers