Table of Contents
Advertisement
Chapter 5 Troubleshooting
This chapter describes the conditions you might have encountered when you use the
Digital Presenter. If you have a problem, refer to the appropriate section and follow all
the suggestions that apply to your problem. If none of the suggested solutions solves
the problem, call your dealer or your service center.
Problem 1: No picture from the Digital Presenter.
Solution -
1: Wait a few seconds, press desired source selector again.
2: Press a different source, then press-desired source again.
3: Check if the power of the Digital Presenter is turned on.
4: Make sure the document or object is positioned under the camera.
Problem 2: Cannot Focus, camera will not focus properly.
Solution - To properly focus: Zoom in as far as possible on the document or object,
focus, then zoom out to desired distance.
Problem 3: Image is too bright or dark, cannot see desired part of the image
because it is too bright or dark.
Solution – Adjust the Control Knob Button on the Digital Presenter.
14
Advertisement
Table of Contents
