Table of Contents
Advertisement
Chapter 11 Troubleshooting
This chapter describes problems you may encounter while using DVP508. If you
have questions, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact our distributors or service
center.
No.
Issues
Boot without power
1
2
No image output
DVP508
from the
Unable to focus
3
The image is
4
incomplete
Forget the
5
password for
turning on
Dukanes Document
6
Camera, Dukanes
and other
applications cannot
be used
simultaneously
7
When the unit is
turned on, the
auxiliary floodlight
Make sure you have plugged in the power cord.
1. Check the power.
2. Check the connection, Refer to
Chapter 4 Installation and Connections
3. Check the
, refer to
Descriptions of major functions 8.3 I would like to
switch image
sources.
4. Check the settings for the source of the projector. For
the appropriate input selection of the projector, refer to
the projectors user manual.
5. Check if DIP Switch is properly set. Refer to
Manual Chapter 6 DIP Switch Settings
settings.
Probably the document is too close. Press [Zoom -] on the
remote control or control panel. Or pull away the
distance between document and lens, then press [AF].
Check the Auto Image setting of your projector. Please refer
to the user manual of the projector.
Please contact your distributor or the service center.
Document Camera, Dukanes and other
Dukane
applications cannot be executed simultaneously. Please
close the currently running applications and then execute
the application to be used.
Please make sure the arm lamp is set to [OFF]. For the
switch-on or -off of arm lamp, refer to
Chapter 8 Descriptions of major functions 8.8 I would
Solutions
User Manual
User Manual Chapter 8
User Manual
User
for related
English - 41
Advertisement
Table of Contents
