Table of Contents
Advertisement
Chapter 11 Troubleshooting
This chapter describes problems you may encounter while using DVP507. If you
have questions, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact our distributors or service
center.
No.
Issues
1
Boot without
power
2
No image output
from the DVP507
3
Unable to focus
4
The image is
incomplete
5
Forget the
password for
turning on
6
Visual Presenter
V2, B-Works or
other application
cannot be
executed
simultaneously
DUKANE AV DIVISION
Make sure you have plugged in the power cord.
1. Check the power.
2. Check the connection, Refer to
Chapter 4 Installation and Connections
3. Check the [Source]; refer to
Descriptions of major functions 8.1 I would like to switch
image
sources.
4. Check the settings for the source of the projector. For
the appropriate input selection of the projector, refer to
the projectors user manual.
5. Check if DIP Switch is properly set. Refer to
Manual Chapter 6 DIP Switch Settings
settings.
Probably the document is too close. Press [Zoom -] on the
remote control or control panel. Or pull away the
distance between document and lens, then press [AF].
Check the Auto Image setting of your projector. Please refer
to the user manual of the projector.
Please contact your distributor or the service center.
Visual Presenter V2, B-Works and other applications
cannot be executed simultaneously. Only one application
can be executed at a time. Please close the currently
running applications and then execute the application to be
used.
Solutions
This User Manual
This User Manual Chapter 8
for related
This User
41
Advertisement
Table of Contents
