Table of Contents
Advertisement
6. Control
6.3
Switching the device off
Quickly press the control button (2) on the control unit body (1). Upon the
for a second time; the
the button for the fourth time. No icon will be displayed. The device is now off.
If the switching-off sequence has not been completed, device will remain in ON mode.
6.4
Switching the device on into UP-mode
If the landing location is higher than the take-off location, it is necessary to reset the device for the altitude difference in advance. The m
allows for upward adjustments between 10 m to 990 m (10 to 2,990 ft). If your device is in the meter version, you will be entering three
positions. If your device is in the feet version, you will be entering four positions. The last position is always zero. All positions must be entered,
including the zeros in the initial positions, if those are zeros. If you enter all zeros, the memory will retrieve the value last used in the UP mode.
Example of the procedure in meters:
The take-off location, device activation and calibration before jumping are at an altitude of 450 m above sea level. The planned landing
area after diving is at an altitude of 700 m above sea level. The elevation difference is 700 – 450 = 250 meters.
First, switch off the m
press the button for a second time, the
displayed; do not press anything now, wait. After a short time, the
time and the digits 0, 1, 2, .... 8, 9 will sequentially show up on the display. Pressing the button upon digit 2 being displayed will preset
2 x 100m. Then the digits 0, 1, 2, .... 8, 9 will again be displayed. Pressing the button upon digit 5 being on the display will add a further
5 x 10m. The display will show 0. Press the button and the setting is confirmed. The display will automatically sequentially show the
icons "-" "2" "5" "0" "-" (four digits in the feet version) for your verification and the device will complete the auto-test
Higher located
landing area
icon will be displayed; immediately press the button for a third time; when the
. Shortly press the control button (2) on the control unit body (1). Upon the
2
icon will be displayed; immediately press the button for a third time, the
icon being displayed (3) immediately press the button
icon being displayed (3) immediately
icon will be displayed; Immediately press the button for the fourth
icon is displayed, press
2
icon will be
20
Advertisement
Table of Contents
