Table of Contents
Advertisement
3. Function
3.2.1
STANDARD-mode
The STANDARD-mode is used always when the skydiver starts and lands at the same location, same drop zone and doesn't need to
change the device parameters. Landing location is at the same elevation above sea level as the aircraft take-off location. The display
shows the
icon. When using this mode, always switch the device on at the landing location.
The m
device requires for the aircraft to ascend up to at least 40 m (130 ft) in order for correct start detection and to remain above
2
this altitude until the skydiver's jump. Further, depending on the device version, it is necessary to exceed the preset altitude lock
by either 450 m (1,475 ft), or 900 m (2,950 ft) to unlock the device.
+450 m / + 1,475 ft (+900 m/ +2,950 ft for Tandem)
+40 m / + 130 ft
Ground
zero
Restricted area
8
Advertisement
Table of Contents
