Table of Contents
Advertisement
6. Control
6.6
Switching the device on into X-mode
(Only for devices with firmware 2xxx and higher)
Shortly press the control button (2) on the control unit body (1). Upon the
for a second time, the
press anything now, wait. After a short time, the
Immediately press the button for the fourth time. The device will complete the auto-test and calibration – flashing the
the
icon will be displayed, indicating the device is switched on in the X mode.
Information in the device memory - MENU
6.7
MENU display description
6.7.1
The m
retains information which is available to the user upon following the steps below. The following information can be found in the m2 memory.
2
Opening altitude of the last jump (in meters, 4 digits = 0000 to 9999m)
(in feet, 5 digits = 00000 to 99999 ft)
The opening altitude will not appear if the falling speed is not exceeded during a jump, such as in hop & pop, static line opening, etc.
The total number of dives during the device's operation (5 digits = 0–99999 jumps);
The number of jumps will increase by one each time the altitude lock is released, which already occurs in the airplane at an altitude of 450 m
(1,475 ft) or 900 m (2,950 ft) above the take-off location during the ascent of the aircraft, regardless of whether the jump was actually performed.
Landing location correction (in meters, 3 digits = 000 to 999 m) (in feet, 4 digits = 00000 to 9999 ft)
icon will be displayed; immediately press the button for a third time, the
icon will be displayed; next,
icon being displayed (3) immediately press the button
icon will be displayed; do not
will be followed by
(the so-called x-mode).
icon. Next,
22
Advertisement
Table of Contents
