Table of Contents
Advertisement
5. Installation
b)
c)
The thick cable of the control unit is always second and must be placed
Cable of Control Unit
on the wound thin cable. If the m
that the thick cable is higher than the thin cable, wind the cable counter-
clockwise from the front view. If the set and device are placed in the
opposite direction, then it is the reverse.
Both folded cables are secured with the Velcro strap.
Cable of Cutter
Avoid sharp bends, knots and mutual entanglement of cable while
Cable of Control Unit
placing cables! Place the cables in such a way that they are loose
enough to avoid tension between the individual parts of the device!
Adhere to minimum radius for cable winding r = 25 mm! Bending
a strong cable can result in its damage and subsequent defective
function of the m
Avoid pulling on the cables, particularly the control unit and the cutter.
device body is placed in such a way
2
!
2
17
Advertisement
Table of Contents
