Table of Contents
Advertisement
2. Remove the knob for the oven
functions. If there is no access to the
bypass screw dismount the control
panel before adjustment start.
3. With a thin and flat screwdriver adjust
the bypass screw A.
The model determines the position of
the bypass screw A.
A
Changing from natural gas to
liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
3. Connect the appliance to the
electricity.
Changing from liquid gas to
natural gas
1. Unscrew approximately one turn the
bypass screw position A.
2. Put the knob for the oven functions
back.
3. Connect the appliance to the
electricity.
WARNING!
Put the mains plug into
the mains socket only if
all parts are back into
their initial position.
There is a risk of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions
on the minimum position.
6. Remove the knob for the oven
functions again.
7. Screw on slowly the bypass screw till
the flame becomes minimum and
stable.
8. Put the knob for the oven functions
back.
9. Set the maximum gas flow position
on the knob for the oven functions
and let the oven heat for at least 10
minutes.
10. Quickly turn the knob for the oven
functions from maximum to the
minimum gas flow position.
Control the flame. Make sure the flame
does not go out when you turn the knob
to the minimum gas flow position. There
must be a small regular flame on the
oven burner crown. If the flame goes out
adjust the oven burner again.
14.14 Gas grill injector
replacement
1. Release the screws which keep the
grill burner in position A.
2. Release the burner injector with a 7
mm socket spanner and replace it
with a right one.
3. Assemble the burner in a reverse
sequence. Before you fix the screw,
make sure that the burner is pushed
correctly to the back panel.
Test the grill injectors.
ENGLISH
29
A
Advertisement
Table of Contents
