Installation - Electrolux EKG913A2OX User Manual

24 www.electrolux.com
Problem
Steam and condensation
settle on the food and in
the cavity of the oven.
The oven does not heat
up.
The turnspit does not ro‐
tate.
It takes too long to cook
the dishes or they cook too
quickly.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

14. INSTALLATION

WARNING!
Refer to Safety chapters.
14.1 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
Keep a distance of about 1
cm between the appliance
and the back wall to make
sure that the lid opens.
For minimal distances for fitting check
the table.
Possible cause
You left the dish in the
oven for too long.
The necessary settings are
not set.
The turnspit is not correctly
installed into the turnspit
hole.
The temperature is too low
or too high.
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Minimum distances
Dimension
A
Remedy
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Make sure that the settings
are correct.
Refer to "Using the turn‐
spit".
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
B
A
D
mm
400
C
D