Table of Contents
Advertisement
Delay Control
Press "FUNC" button to choose
"DELAY", begin lens delay adjust-
ments. Use the Lens Delay Con-
trol "UP" and "DOWN" buttons to
adjust the time for the lens to
switch to the clear state after
welding or cutting.
•
Weld Mode / Cutting Mode -
No. 0 ~ No. 9
•
Grind Mode - No Delay
Adjustment
The delay is particularly useful in eliminating bright after-rays present in higher
amperage applications where the molten puddle remains bright momentarily
after welding. Use the Lens Delay Control buttons to adjust delay from 0 to 9 (0.1
to 1.0 second). When welding ceases, the viewing window automatically
changes from the darkened state back to light state but with a pre-set delay to
compensate for any bright afterglow on the work piece. The delay time/response
can be set from 0 to 9. It is recommended to use a shorter delay with spot weld-
ing application and a longer delay with applications using higher current. Longer
delays can also be used for low current TIG welding in order to avoid the lens
lightening when the light path to the sensors is temporarily obstructed by a hand,
torch, etc.
7
Advertisement
Table of Contents
