Table of Contents
Advertisement
This Auto-Darkening Welding Goggle will automatically change from a light
state (shade 3.5) to a dark state (Shade 5-13) when arc welding starts.
The filter automatically returns to a light state when the arc stops.
Match your welding application to the shade indicated on the shade chart.
(See Page 6)
• Operating temperature: 14°F ~ 131°F
• Do not use or open the auto-darkening filter if damaged by shock,
vibration or pressure.
• Keep the sensors and solar cell clean. Clean the goggle filter using soapy
water solution and soft cloth which should be damp but not saturated.
This Auto-Darkening Welding Goggle is designed for use with GMAW,
GTAW, SMAW welding, or Plasma Arc and air carbon cutting.
The goggles provide protection from harmful UV and IR radiation, in both
dark and light states.
The goggles contain four sensors to detect the light from the welding arc, re-
sulting in the lens darkening to a selected welding shade.
• Do not use solvents or abrasive cleaning detergent.
• If cover lens is spattered or covered with dirt, it should be replaced
immediately.
• Use only replacement parts specified in this manual.
• Do not use the goggles without inside and outside cover lenses properly
installed.
WELDING GOGGLE INFORMATION
(-10°C ~ 55°C).
2
Advertisement
Table of Contents
