Table of Contents
Advertisement
Rexroth IndraDyn A
10.4 Transport and Storage
General Information
Notes for Transport
DOK-MOTOR*-MAD/MAF****-PR03-EN-P
Damages or injuries and invalidation of the
warranty due to improper handling!
⇒ Protect the products from dampness and corrosion.
⇒ Avoid mechanical stressing, throwing, tipping or
CAUTION
dropping of the products.
⇒ Only use lifting equipment suitable for the weight of
the motor.
⇒ Never lift the motor out of the fan housing.
⇒ Use
protective clothing during transport.
Notes:
• Permitted transport temperature range: -20°C to +80°C.
• Permitted storage temperature range: 0°C to +45°C.
• After storage of one to five years, the motor must warm up
for one hour at 1000 rpm before starting normally.
• The max. permitted storage duration of the motors is 5
years. After the max. storage duration is exceeded, the
bearing grease must be replaced.
• Also observe the notes regarding storage and transport on
the packages.
To protect the motor from dirt, dust etc., Bosch Rexroth recommends to
transport the motor
• to the intended installation site and
• to keep it until the actual time of installation into the machine
in the packaging in which it has been delivered from Rexroth.
To lift the motor from the transport crate or to install it into the machine,
use the transport or lifting eye bolts at the motor.
The lifting eye bolts comply with the requirements of DIN 580 as a
minimum. Before each transport, ensure that the lifting eye bolts are
screwed down fully to the stop face and that your selected lifting
equipment and lifting method will not overload the lifting eye bolts.
Note:
Please note the DIN 580 standard on transport of motors by
means of the attached lifting eye bolts. Non-observance of the
information in this standard may cause overload of the lifting
eye bolts and result in injury to persons or damage to
products.
Handling and Transport
suitable
protective
equipment
10-3
and
wear
Advertisement
Table of Contents
