Table of Contents
Advertisement
Rexroth IndraDyn A
Protection During Handling and Mounting
Battery Safety
DOK-MOTOR*-MAD/MAF****-PR03-EN-P
Safety Instructions for Electric Drives and Controls
In unfavorable conditions, handling and assembling certain parts and
components in an improper way can cause injuries.
Risk of injury by improper handling! Bodily
injury by bruising, shearing, cutting, hitting!
⇒ Observe the
regulations on handling and assembly.
CAUTION
⇒ Use suitable devices for assembly and transport.
⇒ Avoid
measures.
⇒ Always use suitable tools. Use special tools if
specified.
⇒ Use lifting equipment and tools in the correct
manner.
⇒ If necessary, use suitable protective equipment (for
example safety goggles, safety shoes, safety
gloves).
⇒ Do not stand under hanging loads.
⇒ Immediately clean up any spilled liquids because of
the danger of skidding.
Batteries consist of active chemicals enclosed in a solid housing.
Therefore, improper handling can cause injury or damages.
Risk of injury by improper handling!
⇒ Do not attempt to reactivate low batteries by heating
or
cauterization).
CAUTION
⇒ Do not recharge the batteries as this may cause
leakage or explosion.
⇒ Do not throw batteries into open flames.
⇒ Do not dismantle batteries.
⇒ Do not damage electrical parts installed in the
devices.
Note:
Environmental protection and disposal! The batteries installed
in the product are considered dangerous goods during land,
air, and sea transport (risk of explosion) in the sense of the
legal regulations. Dispose of used batteries separate from
other waste. Observe the local regulations in the country of
assembly.
general
construction
jamming
and
bruising
other
methods
(risk
3-11
and
safety
by
appropriate
of
explosion
and
Advertisement
Table of Contents
