Can-Am 570 Series Operator's Manual page 143

NOTE: It is normal that the beadlock
clamp ring flexes slightly to match the
tire bead.
Wheel Beadlock Gap Verification
1. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the ring.
219001737-002_a
TYPICAL
A. Gap between tire and ring
If the gap is not acceptable, see an au-
thorized Can-Am dealer.
Instructions about the safe use of
jacks and recommended jacking
points
1. Select the 4WD mode, press the se-
lector on 4WD.
V07I0DY
4WD MODE
NOTE: 4WD mode is engaged when
engine is running and vehicle has
moved about one meter.
2. To change the transmission posi-
tion, completely stop vehicle, apply
and hold brakes, then move lever to
the desired position. Do not force
lever. If unable to shift, rock the ve-
hicle back and forth and try again.
P:PARK This position locks the trans-
mission to help prevent vehicle move-
ment. Always use when the vehicle
is not in operation. In some circum-
stances, it may be necessary to rock
the vehicle back and forth to move the
gears in the transmission to allow the
park to be engaged.
NOTE: The PARK position is used as a
mechanical parking brake.
______________
II MAINTENANCE PROCEDURES
141