What To Do If Vehicle Is Turned Over; What To Do If Vehicle Is Immersed In Water - Can-Am 570 Series Operator's Manual

Table of Contents

Advertisement

VIII SPECIAL PROCEDURES
3) What to Do if Vehicle is
Turned Over
When vehicle is turned over or stays
tilted on the side, put the vehicle back
on its wheel. Inspect vehicle for dam-
ages.
WARNING
Never operate the vehicle if dam-
aged.
Refer to an authorized
Can-Am dealer.
If vehice has no damage, refer to
MAINTENANCE
the following.
– Inspect air filter housing for oil accu-
mulation, if any oil is found, clean air
filter and air filter housing.
– Check engine oil level and refill if
necessary.
– Check engine coolant level and refill
if necessary.
– Check gearbox oil level and refill if
necessary.
– Check rear final drive oil level and re-
fill if necessary.
– Start engine. If the oil pressure light
stays on, stop engine immediately.
See an authorized Can-Am dealer.
Whenever the vehicle is turned over, it
should be inspected by an authorized
Can-Am dealer.
4) What to Do if Vehicle is
Immersed in Water
Should the vehicle become immersed,
immediately stop the engine. Do not
use:
– Any electrical equipments
– Winch (if equipped)
It will be necessary to take the vehi-
cle to an authorized Can-Am dealer as
soon as possible. NEVER ATTEMPT
TO START THE ENGINE!
______________
110
section and inspect
NOTICE
Immersion of the vehi-
cle can cause serious damage if the
correct restart procedure is not fol-
lowed.
As soon as vehicle is pulled out of wa-
ter, carry out the following:
– Drain CVT. See procedure in this
subsection.
NOTICE
The vehicle should be ser-
viced as soon as possible by an au-
thorized Can-Am dealer.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

650 series1000 series

Table of Contents