Spark Plugs - Can-Am 570 Series Operator's Manual

V07I0JY
TYPICAL
NOTE: Place a rag around the throttle
cable adjuster to prevent the lubricant
from splashing.
Add lubricant until it runs out at throttle
body end of the throttle cable.
Reinstall and adjust the cable.
Throttle Cable Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
1
V07I0GY
1. Cable protector
2. Throttle cable adjuster
3. Lock nut
4. Throttle lever housing
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free play.
Measure throttle free play at the tip of
throttle lever.
2 3 4
V07I010
1. Throttle lever
A. 2 mm (.079 in)
Tighten lock nut and reinstall protector.
With the shift lever on PARK position,
start the engine.
Check if the throttle cable is adjusted
correctly by turning handlebar fully to
the right then fully to the left. If the
engine RPM increases, readjust the
throttle lever free play.

10) Spark Plugs

Spark Plug Access
Remove side panels.
Unplug spark plug cables.
Spark Plug Removal
Unscrew spark plugs one turn.
CAUTION Always wear safety
goggles when using pressurized air.
Clean spark plugs and cylinder heads
with pressurized air if possible.
Unscrew spark plugs completely then
remove them.
______________
II MAINTENANCE PROCEDURES
1
A
133