Epever MPPT Tracer1206AN User Manual page 25

C. Low Voltage Reconnect Voltage > Low Voltage Disconnect Voltage ≥ Discharging Limit Voltage.
D. Under Voltage Warning Reconnect Voltage>Under Voltage Warning Voltage≥ Discharging Limit
Voltage;
E. Boost Reconnect Charging voltage> Low Voltage Reconnect Voltage;
F. Low Voltage Disconnect Voltage ≥ Over Discharging Protection Voltage (BMS)+0.2V
The required accuracy of BMS is no higher than 0.2V. We will not assume
responsibility for the abnormal when the accuracy of BMS is higher than 0.2 v.
CAUTION
4) Load mode setting
When the LCD shows the above interface, operate as follows:
Operation:
Step1: Press the SELECT button to browse the load mode interface.
Step2: Press and hold the ENTER button until the load mode interface begins to flash.
Step3: Press the SELECT button to modify the load mode.
Step4: Press the ENTER button to confirm.
① Load mode
1**
100 Light ON/OFF
101 The load will be on for 1 hour
since sunset
102 The load will be on for 2 hours
since sunset
103 The load will be on for 3 ~13
~113 hours since sunset
114
The load will be on for 14 hours
since sunset
115 The load will be on for 15 hours
since sunset
116 Test mode
117
Manual mode(Default load ON)
Timer 1 2**
2 n Disabled
201 The load will be on for 1 hour before
sunrise
202 The load will be on for 2 hours before
sunrise
203 The load will be on for 3 ~13 hours
~213 before sunrise
214
The load will be on for 14 hours before
sunrise
215 The load will be on for 15 hours before
sunrise
2 n Disabled
2 n
Disabled
21
Timer 2