Epever MPPT Tracer1206AN User Manual page 22

BCV 14.4V
FCV 13.8V
LVR 12.6V
LVD 11.1V
LEN
The SYS value can only be modified under the non-lithium "USE" type. That is, the battery type
is Sealed, Gel, or Flooded before entering the "USE" type, the SYS value can be modified; if it is
lithium battery type before entering the "USE" type, the SYS value cannot be modified.
Only the above battery parameters can be set on the local controller, and the remaining battery
parameters follow the following logic (the voltage level of 12V system is 1, the voltage level of 24V
system is 2).
Battery type
Battery
parameters
Over voltage
disconnect voltage
Charging limit voltage
Over voltage reconnect
voltage
Equalize charging
voltage
Boost reconnect
charging voltage
Under voltage warning
reconnect voltage
Under voltage warning
voltage
Discharging limit
voltage
④ Battery voltage parameters

Measure the parameters in the condition of 12V/25º C. Please double the values in the 24V
9~17V
9~17V
9~17V
9~17V
NO YES/NO
Sealed/Gel/Flooded
User
BCV+1.4V*voltage
level
BCV+0.6V*voltage
level
BCV+0.6V*voltage
level
BCV+0.2V*voltage
level
FCV-0.6V*voltage
level
UVW+0.2V*voltage
level
LVD+0.9V*voltage
level
LVD-0.5V*voltage
level
1) Press the ENTER button again to display the
current voltage value.
2) Press the SELECT button to modify the parameter
(short press to increase 0.1V, long press to
decrease 0.1V).
3) Press the ENTER button to confirm and enter the
next parameter.
Press the SELECT button to modify the switch status.
Note: It exists automatically from the current interface
after no operation of more than 10S.
LiFePO4 User
BCV+0.3V*voltage
level
BCV+0.1V*voltage
level
BCV+0.1V*voltage
level
Boost charging
voltage
FCV-0.6V*voltage
level
UVW+0.2V*voltage
level
LVD+0.9V*voltage
level
LVD-0.1V*voltage
level
18
Li(NiCoMn)O2 User
BCV+0.3V*voltage
level
BCV+0.1V*voltage
level
Boost charging voltage
Boost charging voltage
FCV-0.1V*voltage level
UVW+1.7V*voltage
level
LVD+1.2V*voltage level
LVD-0.1V*voltage level