4.3 Connecting The Hardware
1) Perform the mechanical installation as detailed in Section 3.
2) Install the APT Software - see Section 4.1.
3) Using the USB cable supplied, connect the stage unit to your PC.
The USB cable should be no more than 3 metres in length. Communication
lengths in excess of 3 metres can be achieved by using a powered USB hub).
4) Connect the flipper to the power supply unit (PSU) - see Section 4.2.1.
5) Connect the PSU to the mains supply wall outlet and switch 'ON' if required.
6) Wait for the unit to initialize (about 5 sec). Do not press any controls durin g this
time.
TM
7) Windows
drivers for the new hardware - see the Getting Started guide for more information.
should detect the new hardware. Wait while Windows
MFF101 and MFF102 Motorized Filter Flippers
Note
TM
installs the
15
Need help?
Do you have a question about the MFF101 and is the answer not in the manual?