Midtronics GRX-3590 Quick Reference Card

QUICK REFERENCE CARD GRX-3590
ALWAYS WEAR SAFETY GLASSES WHEN WORKING WITH BATTERIES!
VISUAL INSPECTION
• Plug the charger in a grounded 16 amp outlet.
• Always visually inspect the battery before charging, if
there are any signs of a leaking or cracked case, the bat-
tery should be discarded.
• Check fluid levels before charging. Do not overfill water
levels should only cover the top of the plates. Be sure
to remove any excess water before charging, to avoid
overflow.
• Promptly clean acid spills with baking soda and water.
• Place the battery in a safe, well-ventilated area when
charging.
• If at any time the GRX needs to be stopped, press the
STOP button and the session will be aborted.
Connect the charging clamps to the battery in accordance with all precautions and safety instructions.
Do not connect either clamp to the vehicle's chassis.
1. Connect the red clamp to the positive (+) terminal and the black clamp to the negative (–) terminal.
If you connect the clamps in reverse (red to negative or black to positive), the analyzer sounds an alarm and
displays REVERSE CONNECTION! Reconnect the clamps correctly.
To make sure both sides of the clamps are gripping the terminals, rock the each clamp back and forth.
A poor connection will prevent testing, and the analyzer displays CHECK CLAMP CONNECTION. If the
message reappears after you have correctly reconnected the clamps, clean the terminals and battery posts and
reconnect.
2. Press the power switch to (ON), the switch is located at the back of the unit.
3. When the unit is used for the first time you will be asked to enter the following information: LANGUAGE, DATE
FORMAT, DATE, TIME FORMAT and TIME
All these settings can be changed later in the UTILITY menu under CONFIG CHARGER
4. Select any icon from the MAIN menu to proceed.
Two softkeys
Arrow softkeys
to navigate
Alpha numeric
keys for input
STARTING-UP
167-000431B GB
FRONT PANEL
January 2016