Table of Contents
Advertisement
232 MONITOR PLUS
status screen (See STATUS, p.18).
PAGE DOWN F4
See F4 (p.10).
PAGE UP F2
See F2 (p.10).
REPORTS [R]
Press [R] to see the Reports sub-
menu (Screen 1 below; you will
encounter a total of three screens in
the Reports submenu.) You have
three options, described below.
[1]
Outputs all data from the buffer in
your choice of notation.
[2]
Outputs all data from the buffer in
your choice of notation and includes
the changes in line signals.
[3]
Outputs all of the text from the 232
Available reports are:
1)All captured data in TEXT and HEX
2)Same as 1 plus Modem Interface History
3)Printout of HELP text
Hit
[1] [2] or [3]
Report can be directed to left parallel
port, or either serial port on the right
Hit [O] for serial or [P] for parallel
Screen 2. Port selection for report output.
20
Screen 1. Reports submenu.
Monitor Plus help facility.
After you press [1], [2], or [3], you
receive a prompt asking you to direct
the report you have chosen to a
specific port for output (see Screen
2 below). Your choices are:
[O]
Will output through both serial ports
on the right side of the 232 Monitor
Plus.
[P]
Will output through the parallel port
on the left side of the 232 Monitor
Plus.
After you press [O] or [P] you will
see the Screen 3, shown at the top of
the next page.
Interpret the screen as follows:
Advertisement
Table of Contents
