Data Printout And Digital Output Through Connector Ports - Proceq Equotip 3 Operating Instructions Manual

7.2. Data printout and digital output through connector ports

The Equotip 3 is equipped with USB, Ethernet and RS 232 ports by default:
• USB type A: Connector socket for keyboard, mouse, barcode scanner, printer.
• USB type B: Refer to the separate operating instructions "Equolink 3 Software" included
on the Equotip CD.
• Ethernet: Configuration is accessed through "Config" – "System settings" – "IP settings...".
Enter the IP address of the device or use the DHCP option.
• RS 232 (serial): The RS 232 interface can be used for printing, but due to its speed
limitations it is not suitable for device updates.
• Printer setup: Printers can be connected via USB type or RS 232, respectively.
Configuration is accessed through "Config" – "System settings" – "Printer...". Various
printers can be selected from a list. If "Autoprint at end of series" has been enabled, the
indicating device will automatically print a protocol each time a measurement series is
closed. Alternatively, a protocol of the current series can be printed at any time using
"Measurement" – "Print series" – "Long protocol" or "Short protocol".
Note:
i
Communication via Ethernet connection is faster than USB.
Note:
i
The Equotip 3 Automation Package adds another 5-pole DIN plug output.
Refer to the separate operating instructions or contact your Proceq dealer
for further information.
© 2012 by Proceq SA
24