Thermo Scientific TSG Series Installation And Operation Manual page 11

Note: Re-install the front grill after placing the refrigerator in
the desired location and tighten the screw with a screwdriver.
3. Remove bolts (4) holding the unit to the pallet using the
7/16" wrench.
CAUTION: Always use caution when lifting unit
with forklift to ensure not to damage or drop unit.
4. Carefully position forks to lift unit from rear. Ensure unit is
fully positioned on fork truck prior to raising the forks.
5. For single door units: Raise the unit approximately six
inches to allow access to the feet and casters.
Person 1: Stand at the front of the unit and provide
additional support to the unit. Person 2: If feet are
desired, lower all 4 factory installed feet (using the 3/8"
wrench to loosen if necessary). If rolling casters are
desired, remove the feet and install the 4 casters and
tighten using wrench.
6. For double door units: Raise the unit approximately six
inches to allow access to the Leg Levelers.
Person 1: Stand at the front of the unit and provide
additional support to the unit.
Person 2: If Leg Levelers are desired, lower all 4 factory
installed Leg Levelers. For casters, remove the 8 Hex
Head Bolts, 8 Nuts and 8 Washers fitted with levers using
the wrench and keep aside (to be re-used to mount
casters).
6a. Remove the 4 leg levelers and discard.
6b. Install the 2 casters with lock in the front of the cabi-
net with 8 sets of 5/16-18x1" Hex Head Bolts,
5/16" Nuts and 7/8" O.D. washer, supplied with the
package 4 sets of (4) 5/16-18 x 1 Hex Head Bolts,
Nuts.
General Purpose Freezers
6c. Re-use the 8 sets of 5/16-18x1" Hex Head Bolts,
5/16" Nuts and 7/8" O.D. washer, to install the 2
casters without lock in the rear of the cabinet.
Note: Some casters lock and others do not. It is advised to
install the locking casters on the front of the unit.
7. Remove pallet from below the unit and gently lower unit
in desired location.
Remove these Bolts, Nuts
and Washers (8 places) and
Re-use to mount casters.
Remove these Leg Levelers
(4 places) and discard
Figure 1. Caster Installation
DANGER : Do not tip unit more than 10 degrees
during caster installation. Overturning may result
in serious injury or death.
Table 4. Caster Installation Spar
S. No. Parts
5/16-18x1" Hex Head Bolts
1
(8 supplied with kit, 8 re-used)
5/16" Nuts
2
(8 supplied with kit, 8 re-used)
7/8" O.D. washer
3
(8 supplied with kit, 8 re-used)
Caster with Lock (2 in the front)
4
Caster without Lock (2 in the rear)
5
2
4 5 3 1
e Parts
Installation | 7