Installation; Location; Leveling The Unit; Pallet Removal And Caster Installation Instructions - Thermo Scientific TSG Series Installation And Operation Manual

Installation

WARNING: Do not exceed the electrical rating
printed on the data plate located on the upper left
side of the unit.

Location

Install the unit on a level area free from vibration with minimum
3 inches of clearance on all sides and 4 inches on top. Do not
position the equipment in direct sunlight or near heating
diffusers, radiators, or other sources of heat.
CAUTION: Do not move the unit in fully loaded
condition.

Leveling the Unit

The Freezer must be level in order to provide adequate
condensation drainage as well as proper door alignment and
operation. The Freezer should be in its final operating location
and set so that it is firmly positioned on the floor. Level the
cabinet front to rear and side-to-side using the corner leveling
screws. The front leveling screws are accessed by removing
the base grill, as described below:
1. Remove the lower grill attachment screws
2. Grasp the grill with both hands
3. Lift the grill approximately 1/2"
4. Pull grill away from the Freezer
CAUTION: An unlevel unit may result in instability
and performance issues for the doors and
drawers.
6 | Installation
Pallet Removal and Caster
Installation Instructions
CAUTION: Avoid damage to the refrigerant
tubing which may cause a refrigerant leak while
handling, moving and operating this unit.
CAUTION: Removal of pallet and caster
installation must be performed by an authorized
service personnel only.
With Forklift
Required Tools for Double and Triple Door Unit:
Phillips head screwdriver, 5/16"-18" bolts and a minimum of
2 people.
The following instructions demonstrate how to remove the
cabinet from its shipping base (pallet), install the casters
or lower legs using a fork truck. And 7/16" wrench for
removing lag bolts from the pallet as mentioned below
CAUTION: The unit should be unpacked near
the desired location to avoid the risk of damage
while shifting.
1. Remove the packaging and kick plates from unit.
Remove additional packaging to access the interior of the
cabinet. Be sure to keep one cardboard corner for
subsequent step and one screw in the bottom center of
the grill.
2. Using a screwdriver, remove the screw holding on the
front grill. Lift grill upwards and pull away from unit to
remove. Set aside.
:
General Purpose Freezers