Engineering Setting - Gree CE52-24/F(C) Owner's Manual

Centralized Controller

5.11 Engineering Setting

On the home page, press
Press the "Project Setting" button to switch to engineering setting, the operation
method is the same as the setting of this unit.
(1) Indoor unit register
Enter into the indoor unit register interface, select the chosen indoor unit
according to the displayed engineering No. of indoor unit icon, and then press
to save, it will display the registered indoor unit in the indoor unit page.
NOTES:
① There are 255 sets of indoor units can be registered at most.
② If internal or external main boards are replaced or outdoor unit SA2
address dial code is changed.it need to re-register indoor units.
(2) Name&Icon setting
Switch to name&Icon setting interface to select the engineering No., and set
the name and icon of indoor unit.
Press the Engineering No. to select the required indoor unit that needs to be set.
1) Name: can input number or letter (it should not be over 10 letters)
2) Icon: press to select the preset icon.
3) Engineering No.: it can be set to be 1-255.
to enter into setting page.
Fig. 5.15 Setting Page of Indoor Unit
44