Table of Contents
Advertisement
Options
N8481A Option 200
The N8481A power sensor is fitted with Type- N (m) connector as
standard. Users can choose the sensor to be fitted with APC- 7 connector
by choosing the Option 200.
N8485A Option 033
The N8485A power sensor with Option 033 is calibrated to measure power
levels in the 10 MHz to 33 GHz frequency range.
The N8485A Option 033 power sensor is fitted with a 3.5 mm(m) connector.
N O T E
N8480 Series power sensors with Option CFT
The N8480 Series power sensors with Option CFT covers –30 dBm to
+20 dBm in a single power range and allows users to use the calibration
factor in two methods:
• manually enter the calibration factor for a particular frequency prior to
• manually enter the sensors calibration factor table and select the
The calibration factor data is provided on the label attached to the power
sensor's cover. This calibration factor is used to make frequency
dependent efficiency correction and it is unique to each sensors.
For Option CFT specifications and characteristics, see
Chapter 2, "Specifications and Characteristics."
• The calibration factor table stored in the EEPROM is not applicable for N8480 Series power
N O T E
• Please refer to the respective power meter's User's Guide on how to make a measurement using
N8480 Series Power Sensors Operating and Service Guide
make a measurement; or
frequency of the signal to be measured
sensors with Option CFT.
the calibration factor table.
Introduction
1
15
Advertisement
Table of Contents
