Table of Contents
Advertisement
Operating modes
4.4.5. Alternate flasher mode
In this mode, the outputs Out A and Out B of an output pair are
switched on alternately with an adjustable flashing frequency. The
alternate flasher is started with the command „Straight/Green" of
the assigned button and stopped again with the command „Di-
verging/Red".
Optionally, the output can also be slowly dimmed up and dimmed
down (so-called „zoom" for incandescent lamp simulation).
The alternating flasher operation is ideal for illuminating St.
Andrew´s crosses at level crossings.
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16
keyboard
on
off
GREEN
GREEN
(GREEN
ON)
OFF
ON
1
1
1
(Lenz)
Flash-Time
Flash-Time
Figure 4: Alternate flasher mode
4.4.6. Operating mode switch
With the decoder´s mode switch, you can quickly switch all output
pairs simultaneously to the „k83" or „k84" mode, regardless of
how they might be configured.
Only in the center position „USER" (default setting ex works) the
outputs will behave as programmed in the decoder configuration.
Any configured „zoom" effects are ignored when the mode
switch forces the decoder hard into k83 or k84 mode.
Flash-Time
Flash-Time
RED
RED
OFF
ON
1
1
Stop
time
9
Hide quick links:
Advertisement
Table of Contents
