Chapter 3. Installation; Machine Positioning; Water Connection; Water Inlet Hose - Kernau KDI 4643 User Manual

Table of Contents

Available languages

MACHINE POSITIONING

•

When determining the place to put your machine on, take care to choose a place where you can easily

load and unload your dishes.

•

Do not put your machine in any location where there is the probability for the room temperature to

fall below 0°C.

•

Before positioning, take the machine out of its packaging by following the warnings located on the

package.

•

Position the machine close to a water tap or drain. You need to site your machine, taking into

consideration that its connections will not be altered once they are made.

•

Do not grip the machine by its door or panel in order to move it.

•

Take care to leave a certain clearance from all sides of the machine so that you can comfortably

move it back and forth during cleaning.

•

Make sure that the water inlet and outlet hoses do not get squeezed while positioning the machine.

Also, make sure that the machine does not stand on the electrical cable.

•

Adjust the machine's adjustable feet so that it can stand level and balanced. Proper positioning of the

machine ensures problem-free opening and closing of its door.

•

If the door of you machine does not close properly, check if the machine is stable on the floor it

stands; if not, adjust the adjustable feet and ensure its stable position.

WATER CONNECTION

Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend that you fit a

filter at the entrance of your place or apartment so as to avoid any damage to your machine because of any

contamination (sand, clay, rust etc.) that might be occasionally carried in through the mains water supply or

the indoor plumbing, and to forestall such complaints as yellowing and formation of deposits after washing.

WATER INLET HOSE

Do not use the water inlet hose of your old machine,if any. Use the new water inlet

hose supplied with your machine instead. If you are going to connect a new or long -

unused water inlet hose to your machine ,run water through it for a while before

making the connection. Connect the water inlet hose directly to the water inlet tap.

The pressure supplied by the tap should be at a minimum of 0.03 Mpa and and at a

maximum of 1 Mpa.If the water pressure is above 1 Mpa,a pressure-relief valve

should be fitted in between.

After the connections are made, the tap should be turned on fully and checked for

water tightness. For the safety of your machine, make sure to always turn off the

water inlet tap after each wash programme is finished.

NOTE: Aquastop water spout is used in some models. In case of using Aquastop, a

dangerous tension exists. Do not cut Aquastop water spout. Do not let it get folded or

twisted.

Note printing on the water inlet hose!

If models are marked with 25°, the water temperature may be max. 25 °C (cold

water). For all other models:Cold water preferred; hot water max. temperature 60 °C.