WATER OUTLET HOSE
The water drain hose can be connected either directly to the water drain hole
or to the sink outlet spigot. Using a special bent pipe (if available), the water
can be drained directly into the sink via hooking the bent pipe over the edge
of the sink. This connection should be at a minimum of 50 cm and at a
maximum of 110 cm from the floor plane.
IMPORTANT:
When a drain hose longer than 4 m is used, the dishes might remain dirty. In
that case, our company will not accept responsibility.
ELECTRICAL CONNECTION
•
The earthed plug of your machine should be connected to an earthed outlet supplied by suitable
voltage and current. If there is no earthing installation, have a competent electrician carry out an
earthing installation. In case of usage without earthing installed, our company will not be responsible
for any loss of usage that might occur.
•
The plug on this appliance may incorporate 10A fuse depending on the target country.
•
Your machine is set according to 220-240 V. If the mains voltage in your location is 110 V, connect
a transformer of 110/220 V and 3000 W inbetween. The machine should not be plugged in during
positioning.
•
Always use the coated plug supplied with your machine.
•
Running in low voltage will cause a decline in washing quality.
•
The machine's electrical cable should be replaced by an authorised service or an authorised
electrician only. Failure to do so may lead to accidents.
•
For safety purposes, always make sure to disconnect the plug when a wash programme is finished.
•
In order not to cause an electric shock, do not unplug when your hands are wet.
•
When disconnecting your machine from the mains supply, always pull from the plug. Never pull the
cord itself.
EN
37