Setting Scent Intensity; Scent Control - Prolitec AirQ 270 TT Manual

E
for one second, and the display will show SAVE for
4. Press and hold
about ten seconds.
5. The five buttons will light in sequence from left to right.
6. Remove the SD card; the display will show the currently loaded firmware version and the pump
will run for one second.
:
7. Press to turn on the power.
8. Be sure that the power is on and the appliance is in Run Program mode prior to closing and
locking the door.
9. The new file created on the SD card will be called "outsche.txt." Changing it to "schedule.txt"
allows the programs to be loaded on another appliance.

Setting Scent Intensity

1. Determine the approximate size of the room in cubic feet or cubic meters by multiplying length
x width x ceiling height.
2. Consult the Room-Size Table to give you a level (1 to 50) to set. THIS IS ONLY A STARTING
POINT.
Hint: There are many variables to finding the scent level
that works: size, airflow, number of fresh air changes per
hour, number of people in the space and, most of all, user
preferences. Experiment with different levels until you are
satisfied. Utilize the S3 Tool.

Scent Control

If you followed the Room-Size Chart or S3 Tool, you have set AQ270 to the low end of the range for
your room size. If after one hour you feel the scent is not detectable, increase the setting by about
10%. For example, if your start setting was 20, increase it by 10%, or to setting 22. Keep increasing
until you and others in the space can detect a slight scent throughout the space.
The Last Step
1. Set the appliance to either 24/7 or Run Program.
2. Make sure the power is on.
3. Close and lock the door, storing the key in a known place.
AirQ 270 Chapter 5 OPERATING INSTRUCTIONS
5
19